AATAC CYCLONE SERIES
Standard Equipment
  • 96" Wide Modular Body
  • Dual Hydraulic Pumps
  • Dual Variable Speed Hydraulic
     Planetary Winches
  • 360° Boom End Swivels
  • Power Boom Elevation & Retraction
  • Load Holding Valves on Boom Elevation,
    Boom Extension and all Jacks
  • Front Outriggers w/ Self Storage
  • Four Tie-Back Rings on Tailboard
  • Boom Mounted D-Rings
  • Pre-Assembled & Factory Tested
  • Dual Manual Controls
  • Radio Remote Control
  • Winch Bucket Mounted Pylon w/
    Electrical Collector Ring for 360° Rotation
  • Pressure Gauges
  • Air Winch Freespool
  • Air Wire rope Tensioners
  • Chain Racks & Tool Holders
  • Mud Flaps
  • Deluxe Light Pylon
  • Illuminated Tool Compartments
  • Federal Standard 108 Lighting
  • LED Taillights
  • Houselocks - Secures Wrecker in Stored
    Position
  • 12" Rigid Torsional Resistant Mounting
    Frame
  • 1/2" x 15' Safety Chains
  • 5/8" Hook Adapter
  • Spring Lift Brackets
  • Lo-Pro Fork Receivers
  • Frame Forks, Risers, & Adapters
  • Complete Installation Hardware

Options
  • Tri-Axle Toolboxes
  • Airshift PTO
  • Air and Electrical Hookups
  • Light Bar Packages & Switch Panels
  • Aluminum Decor Kit
  • Convenience Group
  • Work Light Sets
  • Wide Load Tow Light Bar
  • Heavy Duty Truck Tirelift
  • Pintle Hook Attachments
  • Fifth Wheel Plate
  • Snatch Block(s)



SPECIFICATIONS FOR CYCLONE 100
RECOVERY BOOM
Power rating Retracted 100,000 lbs.
Extended 25,000 lbs.
Reach past tailboard at 0° Retracted 24"
Extended 184"

Maximum working height at maximum elevation

 At Rear: 33' at 45°
At Side: 38' at 64°
Range of elevation 0° - 64°
Boom rotation 360° Continuous
Underlift
Retracted capacity 40,000 lbs.
Extended capacity at third stage 16,000 lbs.
Extension past tailboard 128"
Positive tilt 90°
Negative tilt 10°
Winch
Planetary winches (2) 35,000 lbs. each
Wire rope 3/4" x 200'
Ratings are based on structural factors only, not vehicle capability. Product specifications are subject to change without notice.
Chassis Recommended
Minimum front axle GARW 18,000 lbs.
Minimum rear axle GARW 46,000 lbs.

Minimum C.B.
(Cab to Bogie)

2 axle - 180"
3 axle - 204"
Minimum frame length behind center rear axle 36"
RBM (in/lbs.) 3.5 ml.
The outside frame rails of chassis extending behind cab must be free of fuel tanks, air tanks, battery boxes, exhaust stacks, etc.